Switch to a plug and never have a problem in the future. They are sold in
various places including C.A.T.S.
Chuck W5PR
On Thu, Jun 29, 2017 at 5:19 PM, John Simmons <jasimmons@pinewooddata.com>
wrote:
> Buy the longer screws and cut them. The hardware store will have a screw
> cutter that looks like a crimper that will do the job well. Buy extra
> screws in case you cut them too short.
>
> 73,
> -John NI0K
>
> Dave Thompson <mailto:thompson@mindspring.com>
>> Thursday, June 29, 2017 4:23 PM
>>
>> I have two manuals one as CDE and the last as Hy-Gain (not MFJ). 7 of the
>> 8 screws are OK but (stainless Phillips head) but one is a non stainless
>> flat head. I went to Ace hardware and the owner knew what type of screw it
>> is (8-32 left twist thread) but he says they are rare. I hate to use a
>> rusty screw but It looks Ok after spraying with Pre-Lub 6. Does anyone know
>> where I can get at least 8 or more flat head stainless screws. The ones Ace
>> stocks are too long and he was not sure he could order them.
>>
>> These are the screws in the terminal strip part 51465-10) that you attach
>> the rotor cable or quick connect.
>>
>> Thanks in advance.
>>
>> 73 Dave K4JRB
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|