And the bonus on the bowline (bight or not) is that it is easy to untie, should
the need arise. Your arthritic fingers will thank you.
Ed McCann
AG6CX
Sent from my iPhone
> On Nov 27, 2019, at 1:25 PM, Wes <wes_n7ws@triconet.org> wrote:
>
> I'm with the other Wes on this one. If I understand correctly you only have a
> load on the upper side of the knot. I would join the ends with any old knot
> and tie a alpine butterfly loop on the upper side of the knot:
> https://www.animatedknots.com/alpine-butterfly-loop-knot or one I find easier
> to tie, a bowline on a bight:
> https://www.animatedknots.com/bowline-on-a-bight-knot
>
> Wes N7WS
>
>
>> On 11/27/2019 2:06 PM, Wes Attaway (N5WA) wrote:
>> Gedas:
>>
>> You have received a lot of good suggestions. Here is one more, and it is
>> pretty simple. You are apparently not going to be risking anyone's life.
>> You are going to hold up one end of a dipole and there may be 30-40-pounds
>> of tension..
>>
>> I would just join the two ends of the Dacron rope with a simple square knot
>> and with 6-inches or so of each rope sticking out from the knot. Then tie
>> the two ends into a square knot. Tape the ends to the rope if you want to.
>> With constant tension this arrangement will never come loose. I have done
>> this many times over many years with ropes into trees and on towers, etc.
>>
>> Constant tension on the rope will keep the knots nice and tight.
>>
>> -------------------
>> Wes Attaway (N5WA)
>> (318) 393-3289 - Shreveport, LA
>> Computer/Cellphone Forensics
>> AttawayForensics.com
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|