On 1/5/2020 21:15, Grant Saviers wrote:
My check for a good crimp is to try to pull the connector off with
force that feels right for the coax type before soldering the pin.
Maybe there is a spec for this.
There certainly is for other kinds of crimped connectors. Crimp tools
for high-rel projects must be calibrated using a pull test.
73,
Scott K9MA
--
Scott K9MA
k9ma@sdellington.us
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|