Get some thin stainless sheet....DX Engineering sells it.
Wrap it around the tower leg and then put your grounding
clamp on it. This is what I do even with my galvanized
tower. Since it is aluminum, you might put some of that
(I can't remember the name) conductive paste meant for
aluminum antennas between the SS and the tower let.
good luck, 73, Phil W5BVB
On 5/11/2020 9:29 AM, Mark Foltarz via TowerTalk wrote:
I can't seem to get a good answer ( even from Alumatower ) on how to ground an
aluminum tower.
I have a T50H on an MP2. I have already installed #2 tinned copper running
out 45 ft with 3 10 ft ground rods cad welded on each leg.
But how do you actually transition from copper wire to the aluminum tower ?
Also, should the MP2 hinge be bridged with copper braid ? Once again, the
issue of the copper braid connecting to the aluminum.
tnx
de KA4JVY
Mark
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|