On 11/11/20 2:51 PM, john@kk9a.com wrote:
Correct , there is a lot of tolerance on extruded tubing and it will likely
require machining to fit together.
John KK9A
Ron Gorski ron-n9au wrote:
No. The 1-1/4 inner tube will not necessarily fit inside the 1-1/2 in tube
because of nominal manufacturing tolerances.
Ron N9AU
You might look at the variety of clamps used in theatrical work
(Cheseboro is one brand) that are used to clamp pipes together. There's
nothing that says your mast has to be in a straight line - you could
overlap two by a foot with a couple clamps.
an example:
https://www.gripsupport.com/post/2017/06/20/new-cheseboro-clamp-design
http://www.clampsunlimited.net/
https://www.mutualhardware.com/
a couple of swivels is one way
http://www.premier-lighting.com/shop/product1239.html
but would be a bit expensive.
Also Pipe Sleeves (designed to join two pipes end to end)
most scaffolding and grip equipment places have a wide variety of this
kind of stuff.
-----Original Message-----
From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of Ross
Tucker
Sent: Wednesday, November 11, 2020 5:51 PM
To: towertalk at contesting.com
Subject: [TowerTalk] Small mast design - comments?
OK, I just submitted an RFQ to Industrial Metal Supply for the following:
Two 12' lengths of 6061 Aluminum tube, 1-1/2" outer diameter, 1/8" wall
thickness.
One 6' length of 6061 Aluminum tube, 1-1/4" outer diameter, 1/4" wall
thickness.
The thick inner tube will be placed inside the joint and pinned. We will use
drive-on steps at the very bottom, a mast bracket at the 2' level, and a
"guy" holding the two masts together over the roofline of the RVs.
Does this sound reasonable? Any additional tips or suggestions before I buy
the materials would be appreciated. Thanks for the help you've already
provided. :-)
Ross, NS7F
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|