Actually guys I am more concerned about insect nest builders here in
Florida ( Wasps and spiders ) clogging up the tubes which later becomes
water dams. People have been known to cause the same problem themselves
on new Rohn 25 because they didn't know the bolts were stored in the legs.
I am in the process of tie wrapping the ends with pieces of
screen....and tie wrapping it on
Dave
NR1DX
On 1/7/2023 8:08 AM, Dennis OConnor via TowerTalk wrote:
The only stuff that actually works. Just a satisfied user here.
I use it on our fertilizer sprayers. If you know anything about fertilizers you
know it eats steel for lunch.And one or two coats of silver or galvanize paint
to block UV rays.
https://www.mrochem.com/BlackStar-Rust-Converter.html
|
|
|
| $0.00 | |
|
|
|
| |
BlackStar Rust Converter | Mr OChem
Get rid of Rust with BlackStar Rust Converter! It Kills rust and chemically
converts it to a durable abrasion & ...
|
|
|
Store horizontal.
Pop plastic tape across the open ends (assuming the tubing is dry on the day
you do that}If you are really anal put a fan to blow on the ends for a few
hours on a warm day and then tape them off.You should be good to go then.
Doc / k8do
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Dave Manuals@ArtekManuals.com www.ArtekManuals.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|