If the screw broke off and is still in the hole, just choose a position
nearby ... drill a new hole ... and tap it for threads for whatever
screw you want to use. You can buy drill bits and taps that are matched
for each other.
Dave AB7E
On 9/26/2023 11:50 AM, Jorge Diez - CX6VM wrote:
Hello
I needed to remove the PST61D POT, and the small screw that fix the
bottom plate where broken, they are really too small
It's difficult to find this same crew, so any idea how to fix it?
I don´t want to seal it since if I need to remove it again, will be very
difficult
thanks in advance!
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|