My grandfather had one of those non-electric soldering irons with a large
copper tip. He heated it on a gas stove that he had in his basement and it
worked pretty well for larger soldering jobs. I wish that I had it.
John KK9A
Roger Parsons ve3zi wrote;
I've been holding off from commenting in case I am laughed at. However, the
climate here is quite similar to Mike's - perhaps a few degrees colder.
When I want to solder in the field, I use a very old fashioned iron, which
is basically a large lump of copper on the end of a handle. This can be
heated red hot on the kitchen (gas) stove, or with a propane torch, and will
hold its heat for many minutes even in windy, freezing conditions. If I am
within a few hundred metres of the house I use the kitchen stove. If I am in
the bush I use the propane torch.
I have no idea whether such an iron can be obtained these days. Mine came
from my grandfather....
73 Roger
VE3ZI
(North-Eastern Ontario)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|