I have a number of DEMI transverters that I use w/ my FT-847. The
STBY port on the back of the FT-847 provides ptt to ground for 70 cm
(pin 2), 2m (pin 4), 6m (pin 5) and HF (pin 3). Pin 1 is ground. I
took an old PS2 mouse and cut off cable at the mouse side and pulled
the extra pin. Then I took a little project box and installed 4 RCA
connectors. Wire it up and you have a nice little remote ptt control
box for hard keying solid state amps and transverters.
Dana
N1OFZ
On May 15, 2006, at 12:33 PM, William Capps wrote:
> Hello
> Has anyone used a yaesu ft-847 with a demi transverter? I need
> advice on how to key the transverter. I am using a TIB interface
> between
> the transverter and the if rig(ft-847).
>
> Thanks and 73 and Good Dx
>
> Bill af4od em72
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
>
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|