Hello,
I am new to this logging system and in the trauma of changing programs again.
I am trying to set up version 10.19 to use a KAM Tnc. The KAM is old,
DABB3095-6.1 but works happily with a couple of other programs.
When I go over to the RTTY Window I get the message:
Rttyrite failed to put |KAM in Host Mode. Please turn the KAM power off,
then back on.
I do as requested but it fails to cure the problem.
Can someone advise me where I am going wrong or what I need to do to solve
the problem.
Please reply directly to me to save cluttering the reflector
73
Roger
G3KWK
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|