Knut,
I am using an Omni VI+. Try setting the baud rate to the rate set on the
radio. I tried mine on auto and it didn't work either but works fine on
4800 baud. Also, make sure you have the address set to 4.
You may also try the IC765 setting. I have been using that setting and it
works as well. You'll need to set the Omni address to 44 if you use this
one.
73 & GL,
Alan N5NA
----- Original Message -----
From: "Knut Baczko" <knut.baczko@t-online.de>
To: <writelog@contesting.com>
Sent: Monday, November 20, 2000 17:20 PM
Subject: [WriteLog] Interfacing OMNI VI (?) with computer?
>
> Hello,
> unfortunately I cannot interface my OMNI VI (model 563) with the computer.
> When I choose OMNI VI in WL nothing happens at all.
> The same hapens when selecting OMNI V. Only when I select the so called
"matrix"
> mode on the OMNI
> one sees a reaction of the computer i.e. it displays different
frequencies. But
> they are crazy
> for instance 13.565.
> For interfacing I am using a "serial modem cable" which works with a TNC
and
> the PTC II modem.
> Is this ok?
> The OMNI is set to 2400 baud and WL to automatic.
> 73 Knut DK5AD/OE2BZL
>
> --
> WWW: http://www.writelog.com/
> Submissions: writelog@contesting.com
> Administrative requests: writelog-REQUEST@contesting.com
> Problems: owner-writelog@contesting.com
>
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|