I sure could use a litttle help.
My new Yaesu FT-920 arrived today and I am trying to configure Writelog to
work with this radio.
I open Wiitelog and go to Setup and then to Ports.
I have the radio connected to com 2.
Rig checked
Selected FT-920 from the list
Baud rate set to Auto
Poll checked
Com PTT set to NO.
CW turned off
DVK type set to none
rotor control set to none in both positions.
Click OK
Radio button says "No Rig!"
My troubleshooting:
In Windows 98SE I have comm 2 set to 9600, 8, N, 1
The Writelog.ini file shows
Com 2 9600, 8, N, 1, p
I reset that line to:
Com 2 4800, 8, N, 2, This is the rate the Yaesu Manual said to set the
com port to.
saved the file then restarted Writelog.
The radio button in the logging window still says "NoRIG!"
I know the com port and the cable are good because I can run my Rig Blaster
from this port with no problems.
I am wondering what I am missing here.
Any help?
Thanks
Thom WI8W
--
WWW: http://www.writelog.com/
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|