Hi Joe & Jim,
Please keep this one on the refector as I want to do the same myself. At
present I run Don AA5AU's set up with my FT1000MP and a demod on both VFO's.
But it is not possible to "enter" a call from the second VFO - so I do an
A/B VFO switch when I find a Mult with the second VFO - works OK but a
little clumsy - SO1-1/2!!
Bob ZL2AMI
----- Original Message -----
From: "Jim Smith" <jimsmith@shaw.ca>
To: "'WriteLog'" <Writelog@contesting.com>
Sent: Tuesday, September 23, 2003 3:15 AM
Subject: Re: [WriteLog] How to ... ?
> Joe,
>
> I tried the AA5AU info and it led me to do what I think you want
> (although don't recall if I had a bandmap for each VFO). Check out
> http://dayton.akorn.net/pipermail/3830/2003-February/068287.html for a
> description of my setup. You won't find the details of how to set up WL
> there but you will see a description of the result. I don't recall
> offhand how I did it as I don't use WL much (and don't know if I
> documented it, either). However, I am going into the CQWW RTTY so I
> will have it working by then.
>
> Anyway, between Don's info and mine I think you should be able to get it
> working. If not, send me an e-mail Wed night and I'll try to send you
> more details (assuming I've had time to get it set up by then).
>
> 73 de Jim Smith VE7FO
>
> Joe Subich, K4IK wrote:
>
> >I've seen AA5AU's site and that's not what I'm looking to do. His
> >setup is dual receive on the single vfo ... not one demodulator on
> >each vfo (with proper frequencies shown for each). The radio is
> >reporting the frequencies for both vfos every 500 ms ... and I've
> >found how to display the bandmap for the second vfo ... but I can't
> >seem to configure "this 'radios' is second vfo."
> >
> >73,
> >
> > ... Joe, K4IK
> >
> >
> >>-----Original Message-----
> >>From: writelog-bounces@contesting.com
> >>[mailto:writelog-bounces@contesting.com] On Behalf Of Jim Smith
> >>Sent: Monday, September 22, 2003 8:02 PM
> >>To: 'WriteLog'
> >>Subject: Re: [WriteLog] How to ... ?
> >>
> >>
> >>Joe,
> >>
> >>Check out http://www.rttycontesting.com/dualrx0.html Works FB.
> >>
> >>73 de Jim Smith VE7FO
> >>
> >>Joe Subich, K4IK wrote:
> >>
> >>>What is the best way to set up WriteLog to make use of the second
> >>>VFO in rigs like the FT-1000D or MP/MKV?
> >>>
> >>>I'd like to be able to use both VFOs for S&P and transmit on either
> >>>just as if they were separate radios (even though they would be
> >>>restricted to the same band) ... even feed a second digital window
> >>>audio from the second VFO (and sum the output audio).
> >>>
> >>>73,
> >>>
> >>> ... Joe, K4IK
> >>>
> >>>
> >>>_______________________________________________
> >>>WriteLog mailing list
> >>>WriteLog@contesting.com
> >>>http://lists.contesting.com/mailman/listinfo/writelog
> >>>WriteLog on the web: http://www.writelog.com/
> >>>
> >>
> >>_______________________________________________
> >>WriteLog mailing list
> >>WriteLog@contesting.com
> >>http://lists.contesting.com/mailman/listinfo/writelog
> >>WriteLog on the web: http://www.writelog.com/
> >>
> >
> >_______________________________________________
> >WriteLog mailing list
> >WriteLog@contesting.com
> >http://lists.contesting.com/mailman/listinfo/writelog
> >WriteLog on the web: http://www.writelog.com/
> >
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|