----- Original Message -----
From: Braco OE1EMS<mailto:oe1ems@emssolutions.at>
To: writelog@contesting.com<mailto:writelog@contesting.com>
Sent: Monday, May 30, 2005 8:38 AM
Subject: [WriteLog] WL and microham microkeyer
during WPX CW i had some problems with WL and microham microkeyer
i was using for CW msg winkey and everything propertly configurated in WL
but CW speed was all the time changeing alone
i was set 35 WPM and after one or 2 cq i was on 32 or on 28WPM down
also find out that getting faster for cq (<<<test>>> callsign callsign
<<<test>>>)
was all the time not faster on test, sometime also sending callsign......
any ideas?
I had exactly the same experience with varying speed, also I found that if I
did a fill with the paddle then the enter key ... which was supposed to send tu
k9dx, sent only a few characters of that message.Also from to time the paddle
was sluggish.
John K9DX
**********************************
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com<mailto:WriteLog@contesting.com>
http://lists.contesting.com/mailman/listinfo/writelog<http://lists.contesting.com/mailman/listinfo/writelog>
WriteLog on the web: http://www.writelog.com/<http://www.writelog.com/>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|