What CI-V address do you have the 746Pro set to? You cannot change the
address in Writelog but must instead change your radio to match
Writelog.
This comes from the WL archives:
To make the 746Pro to work with WL:
1.) Set the CI-V address in the 746Pro to "5ch"
2.) CI-V Baud Rate to "9600"
3.) CI-V Transceive to "ON"
4.) In WL, SETUP I PORTS, select Rig Type as "Icom 756PRO", POLL
checked,
CommPTT=YES.
Hope it's that simple.
73,
Korey
YI9VCQ/KA5VCQ
Baghdad, Iraq
> -----Original Message-----
> From: writelog-bounces@contesting.com [mailto:writelog-
> bounces@contesting.com] On Behalf Of n5ohl
> Sent: Friday, November 04, 2005 12:57 AM
> To: writelog@contesting.com
> Subject: [WriteLog] Need help with Icom IC-746pro and interface cable
>
> I have a new rig, the Icom IC-746pro. Writelog will not read the
frequency.
> I have read the help file several times and even upgraded to the
latest
> version 10.55. My interface cable works fine on Logger 32. When I run
> Writelog there is no other program running. My cable is on comm 1. Any
> help would be appreciated.
>
> Jim Richardson N5OHL
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|