Alfred
Again now everything works find all modes all bands.
I found the answer about insulation transformer without stereo to mon
adaptor.
Before you found my problem where I did'nt install a stereo adaptor to mono
after insulation transformer and there was no audio out.
But it was working in CW & RTTY modes.
The audio was looking ground side.
In CW it was finding its ground by returning toward rigblaster box and to CW
key on the back of the radio so there was a ground side.
In RTTY samething almost except it was finding is ground side across again
rigblaster box and also if needed on the ground side of MIC ground pin on
ACC1 Icom radio.
In SSB mode it was totaly floating / no ground reference.
thanks again
Gilles VE2LX
=============
----- Original Message -----
From: "ve2lx" <ve2lx@sympatico.ca>
To: "witelog group" <writelog@contesting.com>
Sent: Monday, January 28, 2008 7:18 PM
Subject: [WriteLog] SUCCESS wl SSB mode TX across isolation transformers
> Alfred KE1FO
>
> Thank you so much for your rapid support.
> You got it right on the target center it works now on SSB...!
>
> I was in parrallele across the 2 insulation tranformers and no reference
> to ground.
> Following your little sketch and explanation I realised that there was no
> ref to ground side and connections was what we call an open cct.
> I do not have a splitter stereo to mono but instead I installed a stereo
> to mono adaptor which does the same thing and ot works.
>
> I did'nt do that in the last few days because I was afraid to short the 2
> stereo channel together......!
>
> But there is a thing I do not understand at all and it made me search the
> trouble for hours:
> It is that before I make the modification you suggested in SSB & CW it was
> working like a charm ( PTT + AUDIO + power output )
> Is there an explanation out of that......?
>
> I sent this email for the help of the community
>
> Again thank you
> Gilles ve2lx
> =================
> ----- Original Message -----
> From: Alfred Frugoli
> To: ve2lx
> Sent: Monday, January 28, 2008 5:28 PM
> Subject: Re: [WriteLog] writelog across isolation transformers
>
>
> Gilles,
>
> Here's a rough text diagram of my setup that works.
>
> o - sound card stereo output
> |
> |stereo patch cable
> |
> /\ stereo/mono splitter
> | |
> | | mono patch cables
> | |
> x x 1:1 isolation transformers
> | |
> o o input to phone patch input on back of rig
>
> I've provided my isolation in the mono patch cables, where one side of
> the transformer connects to ground or shield and the other side connects
> to the "live" or center conductor.
>
> Hope this is helpful.
>
> 73 de Al, KE1FO
>
> On Jan 28, 2008 4:47 PM, ve2lx <ve2lx@sympatico.ca> wrote:
>
> My writelog software now works on any mode RTTY CW SSB including
> macros.
>
> But I have a problem WITH SSB TX when I add insulation transformers
> (one on RX the other on TX ) in the computer audio output ( there is two
> transformers 1:1 at 600 / 900 ohms in a small box wired in parrallele with
> only two wires to the stereo connectors, one wire to the tip, the other to
> the ground side, and I respected the primary and secondary polarities )
> ...? .
>
> I did'nt connect a secondary line side to a resistor or any other part
> as mentionned in articles ((( because it was working like that before, no
> more then two weeks ago when I decided to use shielded wires which was'nt
> before ( was smal lamp cable )
>
> correction made in this sentence ((( In RTTY & CW I have RX & TX or PTT
> on the rigbalster box and radio but no audio in the radio SSB MODE...
> ? )))
>
> Is there soemeone that an idea
>
> Gilles ve2lx
> =============
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|