Use this link to upload your score.
http://www.ncjweb.com/naqplogsubmit.php
--
73
Steve AI9T
http://www.ai9t.com
QSL via LOTW and EQsL
On 8/8/2010 10:04 AM, Alan Marshall wrote:
> John,
>
> Writelog has a set of functions to control the weighting of the keying. The
> manual will give them to you but if I remember they are:
>
> Shift-Page-Up to increase the weighting and
> Shift-Page-Down to decrease the weighting.
>
> There is also a series of numbers that can be set in the Writelog.ini file
> that will set the starting weighting when starting writelog.
>
> -Alan, W1CCE
>
> ----- Original Message -----
> From: "john battin"<jbattin@msn.com>
> To: "writelog"<writelog@contesting.com>
> Sent: Sunday, August 01, 2010 4:24 PM
> Subject: [WriteLog] K1EL
>
>
>
>> I am trying to get my k1el usb keyer to work with writelog. The keying is
>> good until I fireup writelog and then the weighting goes to very
>> low/choppy. When I close write-log, the keying stays bad until I reset the
>> keyer. I think I have tried everything.. but there must be soomething I
>> am missing.
>> John K9DX
>> _______________________________________________
>> WriteLog mailing list
>> WriteLog@contesting.com
>> http://lists.contesting.com/mailman/listinfo/writelog
>> WriteLog on the web: http://www.writelog.com/
>>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|