WriteLog
[Top] [All Lists]

Re: [WriteLog] How to setup Writelog for W1AW

To: Gary AL9A <al9a@mtaonline.net>, WriteLog Reflector <writelog@contesting.com>
Subject: Re: [WriteLog] How to setup Writelog for W1AW
From: Steve AI9T <steve@ai9t.com>
Reply-to: steve@ai9t.com
Date: Wed, 28 May 2014 21:06:23 -0400
List-post: <writelog@contesting.com">mailto:writelog@contesting.com>
Gary

I always pick DXpedition mode and down at the bottom is always shows General DX Tracking.

--
73

Steve AI9T

http://www.ai9t.com

AI9T DX Cluster

Version 4 AI9T   Telnet: dxc.ai9t.com port 7300
Version 6 AI9T-2 Telnet: dxc.ai9t.com port 7373 (CW + Skimmer)




On 5/28/2014 8:47 PM, Gary AL9A wrote:
Ok, now I need a little help/advice. Taking Jim's suggestion to heart I've been trying to setup a new file for the upcoming W1AW/KL7 portable operation using the DXpedition module. My problem is every time I start a new log and save it when I restart the log it comes up in the DXCC tracking module rather than the DXpedition module. I've never seen this behavior before.

As the young Air Force pilot appearing before an investigation board following the crash of his aircraft stated, "Sir I ran out of airspeed, altitude and ideas all at the same time." Ditto here. Any suggestions?

73,
Gary AL9A

-----Original Message----- From: Jim Reisert AD1C
Sent: May 23, 2014 12:20 PM
To: Gary AL9A
Cc: WriteLog
Subject: Re: [WriteLog] How to setup Writelog for W1AW

On Fri, May 23, 2014 at 10:23 AM, Gary AL9A <al9a@mtaonline.net> wrote:

Jim ADIC just asked essentially the same question recently. The answer is don't use the DXpedition module, but instead use the General DXCC tracking
log module.

I guess it depends on what you want to do.

If you are logging multiple modes on the same band using the same log
file, you *want* DXpedition mode, not DXCC mode.  The reason being
that DXCC mode dupes the stations once per band, whereas DXpedition
mode dupes the stations once per band+mode.  What happened to me this
morning is that all the guys who previously worked me on 30 RTTY were
showing up as dupes on 30 CW.  The other way around is worse, because
you can't use the INSERT key in RTTY on a "duplicate" call to capture
it into the QSO window.

You can still add the STATE field to the DXpedition module if you are
inclined to logging the information that is sent to you.

DXCC mode gives you multiplier stats for each band, regardless of
mode.  DXpedition mode gives you multiplier stats regardless of band
or mode, i.e. the first VK you work on any band counts as a multiplier
for THAT band.  Since this isn't a contest, the reporting of
multipliers is far less important than having dupes identified
correctly.

73 - Jim AD1C


_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>