Wayne,
All my messages DID have an (%E) at the end...with no characters after the
(E). I just brought my msgs in from last years CQWW RTTY (in the old WL
ver) to the new version and when I did that for the RTTY Sprint over the
weekend MSG box msg did not appear. All worked OK. I wouldn't want anything
after the E!
I just opened the set up messages again and hit "no"...the cursor went to
the first (F02) line...all is OK there. And it appears every time I hit OK
when trying to exit the msgs setup screen. Ver. 12.08C
73
Mike W2GR
In a message dated 9/19/2016 3:50:57 P.M. Eastern Daylight Time,
support@writelog.com writes:
> Put all my messages in starting each with %r and ending all with space
> %E... hit ok/apply and a message box appeared with the following: rtty
> memory %E not at end of message. Do you really want that? yes or no.
> [stuff deleted] Finally just closed the whole window and the messages
> seem to just work just fine.
If you answer "No" to the message box "do you really want that?" the
cursor is placed on the (first) message that has a %e not at the end.
Since you don't post a reason you want a message to have characters
after the %e, its likely you really want to fix this as there will be a
problem later: you're going press f-Keys and complain that the message
you wanted to send did not get sent (because the Rttyrite window is
instead sending the left over characters after the %e in the previous
f-key you pressed) and you have to press another f-key and WL sends the
wrong message, etc.
Wayne
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|