> Tom,
> I am just using the remote software with the "Soft win 1" slot to
> get the virtual front panel to the K3. This works fine, the problem
> is in the WriteLog "QSO Entry" panel, "Radio" button, the only choice
> I get is "Manual entry". If I go to the "setup-WriteLog
> Options-Ports" page the com port selection is not showing the "Soft
> win1" or "Rem Slot 1", just com ports. I don't have another K3, etc.,
> just was going to use the virtual front panel of the "Soft win X" type
> of connection. I was just trying to get anything working for the first
> time, then I would worry about a "Front panel" for the radio.
> Gordon - N1MGO
You probably missed the final control site setup instructions way down
at the bottom of this page:
https://writelog.com/remote-control-setup-step-3-rig-control
Wayne
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|