Mine is a homebrew RTTY interface. Have had it for years on several rigs.
Don't know what else to tell you. The audio level using the Monitor volume
control on the rig sounds fine here.
You must have the MONI switch on and then control the volume via the Moni inner
knob of the Moni/Proc volume control on the rig front panel.
Keith W3KB
-----Original Message-----
From: WriteLog <writelog-bounces@contesting.com> On Behalf Of beaudoin
Sent: Wednesday, December 16, 2020 8:41 PM
To: writelog@contesting.com
Subject: Re: [WriteLog] FTdx 5000 low monitor audio
GE Keith
Well FSK is what I use also. And Joe W4TV Yes I read page 81 and
noticed it never mentioned
RTTY. I am about to do some more experimenting now. I wonder
what your interface is
Keith ? If I find any helpful info I will pass it along.
BoB WA1FCN
On 12/16/2020 6:44 PM, Keith Beebe W3KB wrote:
> Monitoring works just fine here on my FTDX 5000 on RTTY. The difference may
> be that I use FSK keying not AFSK.
>
> The volume controlled by the Monitor knob sounds very good.
>
> Keith W3KB
>
>
>
> -----Original Message-----
> From: WriteLog <writelog-bounces@contesting.com> On Behalf Of Joe
> Subich, W4TV
> Sent: Wednesday, December 16, 2020 7:34 PM
> To: writelog@contesting.com
> Subject: Re: [WriteLog] FTdx 5000 low monitor audio
>
>
> FTdx5000 monitor audio is a function of the transceiver. The FTdX5000
> Operating Manual - page 81 only references Monitor in LSB/USB/AM/FM there is
> no reference as far as I can find to a Monitor function for
> RTTY/AFSK-based DATA operation. I suggest you contact Yaesu about
> a "RTTY/Data monitor" capability.
>
> DK II does not have a separate "sound card monitor" function. You can
> connect a *powered speaker* to the u2R Out jack to hear the output of the
> sound card but that is not a supported configuration. A non- amplified
> speaker will not work and will result in "hot mic" type operation.
>
> 73,
>
> ... Joe, W4TV
>
>
> On 2020-12-16 6:53 PM, beaudoin wrote:
>> GE All
>>
>> Well I was struggling trying to get my new FTDX 5000 mp
>> going on RTTY with Microham
>>
>> Digikeyer 2. I finally got a semi-local to sked a qso ....
>> It turns out I was ok but what gave me
>>
>> problem is monitor has no audio to listen to. The
>> local said his is VERY Low. Is it a setting
>>
>> we need to look at?
>>
>> 73 BoB WA1FCN
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|