Amps
[Top] [All Lists]

[AMPS] Splatter and ALC

To: <amps@contesting.com>
Subject: [AMPS] Splatter and ALC
From: philk5pc@connect.net (Phil Clements)
Date: Mon, 09 Jun 1997 00:42:30 -0500
At 12:38 AM 6/9/97 +0000, you wrote:

>Audio reports have NOTHING to do with excessive IMD. IMD is by 
>definition mostly OUT of signal band products, so the other guy's 
>receiver (when tuned to YOUR frequency) does not hear them.
>
snip....

>Then that is almost CERTAINLY due to your exciter and NOT the 
>amplifier. Amplifiers never enhance audio quality, they only degrade 
>it. By the time they degrade it enough for anyone to notice distortion 
>on your operating frequency, you would be trashing the whole band.
snip.....

>Not to be sarcastic to you,  but the notion amps cause " good 
>audio" or "bad audio" seems to come straight from CB band operators. 
>At least that was where I heard it mentioned first. They think 
>class C PA's make the best audio.
snip...

>Unfortunately, this totally untrue idea seems to have worked itself 
>into the Ham area now.

There was a multi-page article in one of the ham magazines years ago
stating that new tubes in a linear amp produce clean, crisp, audio
for a period of time...however long it takes the "new" to wear off
a tube. That graphite 3-500Z's produce far cleaner and crisper audio
than their predecessors, and several other descriptions of how linear
amplifiers can act as audio processors. I don't remember if it was an 
April fool's spoof or not, but several ham factions must share the
blame with the freeband/cb'ers in propagating this nonsense!

I have yet to hear a CW operator brag on how his new amp made his keying
better, but I guess it's coming soon!

(((73)))
Phil, K5PC

 


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm

<Prev in Thread] Current Thread [Next in Thread>