Hello all, (... a question to Rich and others who care to chime in)
>>
>When measuring power out, it's important to measure anode current. If
>the anode current is low, input swr may be causing the problem. If
>the load is other than 50 plus or minus j zero ohms, all power
>measurements are suspect.
>cheers
>Rich...
>
Would there be a specific difference from the cathode current? In
particular, circuits using AB1 vs AB2?
I'm just trying to understand if there is an specific advantage/reason
for the mention of anode vs cathode.
thanks
Skip wv6f
nospam4me@juno.com
P.S. Although the Dentron GLA-1000 project is in "the works" now the
going is slow due to outside obligations. I hope to have the units done
asap.
cheers
_____________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com
Or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|