>So guys, should I bother with fiddling about 0.14 volt? This is 2.7% high,
>per my calculator...
I wouldn't. The error in your multimeter is probably ±5% so you are well
within measurement error tolerance. An additional 0.14 volts won't hurt the
filament.
73,
Jon
KE9NA
-------------------------------------
Jon Ogden
KE9NA
http://www.qsl.net/ke9na
"A life lived in fear is a life half lived."
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|