>
>
>I never get my plate load impedence calculation to agree with Eimac
>data sheets, how does eimac calculate plate load impedance? For ab1
>amplifiers is the multiplying factor 1.8 or 2?
Depends on the zsac. Either figure is close enough. I use [E-anode/2x
I-anode] for tetrodes with handles.
- later, Igor
Rich...
R. L. Measures, 805-386-3734, AG6K, www.vcnet.com/measures
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|