On Sat, 14 Nov 1998 12:14:07 -0800 "kmarch" <kmarch@ix.netcom.com>
writes:
>Does anyone know of a source for inexpensive relays (i.e. less than
>vacuum realy prices) that can switch 1.5kW of RF? This is for a low
>impedence (75 ohm) application, where I don't need speed. So rather
>than vacuum relays, open frame types that can take RF is what I need.
>Any ideas? Bob N7UA
What is wrong with the open frame relays used by any past or current amp
mfg?
Grab a Newark catalog for ideas or better still just buy a relay from
Ameritron....their relay works fine with the 8877 in the AL-1500 or the
3CX1200A7 in the AL-1200.
You did not specify frequency but the above mentioned relays work fine at
least thru 50MHz and 2KW.
73 Carl KM1H
___________________________________________________________________
You don't need to buy Internet access to use free Internet e-mail.
Get completely free e-mail from Juno at http://www.juno.com/getjuno.html
or call Juno at (800) 654-JUNO [654-5866]
--
FAQ on WWW: http://www.contesting.com/ampfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|