Amps
[Top] [All Lists]

[AMPS] Henry Amp Tune Up, Part1a

To: <amps@contesting.com>
Subject: [AMPS] Henry Amp Tune Up, Part1a
From: jreid@aloha.net (Jim Reid)
Date: Thu, 6 May 1999 10:05:52 -1000
Hello to those interested in this topic.

I have sent this note to a few of you directly,  but it has been
bounced by the reflectors.  I have been told by one of
the recipients,  that the reflector machines believe a particular
character combination I used may indicate a potential
problem,  so the note has not been accepted.

I suspect that the way I have described the Henry  output
plate circuit on to the load may be at fault.  So I will now
call that circuit a "pie",  followed by a "dangling" inductor.

Also,  am breaking the post into  parts, as perhaps the length
was the problem,  just not sure.

But,  I would appreciate any comments from those who might be
able to aid in my understanding the proper tune up procedure.
So,  first a few quotes from the Amp reflector:

Dave, K8CC,  wrote,  in part:

> I've found with my Henry that using the old "dip and load" 
>technique always leads to the best operating condx.

End of Part 1a.

73,  Jim,  KH7M


--
FAQ on WWW:               http://www.contesting.com/ampfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>
  • [AMPS] Henry Amp Tune Up, Part1a, Jim Reid <=