Amps
[Top] [All Lists]

[AMPS] PS Step Start Question

To: <amps@contesting.com>
Subject: [AMPS] PS Step Start Question
From: gdaught6@leland.Stanford.EDU (George T. Daughters)
Date: Wed, 1 Sep 1999 12:19:18 +0008

Bill wrote...

> I'm in the process of building the power supply for my amp project. I am
> having problems getting the correct delay in the step start circuit. I
> decided to use the same circuit as the amp project by G. Daughters, K6GT,
> that appears in the most recent ARRL handbook.

Oops... that puts me on stage, I fear.

> I am using a 24 V DC relay that has a coil resistance of approx. 280 ohms
> (Rcoil) and I want to get about a 3-4 second delay in the RC circuit. When
> I got all the parts together I knew the circuit wouldn't work just looking
> at the values, so I mocked it up and it indeed didn't work.

I used a physically small relay, and I think the resistance was much 
higher... but I'm not at home now, so I'll have to wait to confirm 
this.

> The circuit consists of a diode (D5) and 3.9k resistor (R13) in series
> connected to the coil of the 24 VDC relay with a 600 uf capacitor (C11)
> connected across the coil of the relay. 120 volts AC is connected to this
> circuit. This circuit is basically a half-wave rectifier and R13 and the
> Rcoil act as both a voltage divider and resistance for the RC time
> constant. I am only getting about 4 volts across the coil where this relay
> needs a minimum of about 14-15 volts to kick in. This makes sense looking
> at the circuit equations:
> 
>     Vcoil = Vin * Rcoil / ( R13 + Rcoil ) ~= 55 * 280 / (3900+280) ~= 4.0 V
> 
> where Vin was measured and is about 0.45 * 120 volts which makes sense for
> a half-wave rectifier circuit.

This isn't quite right.  A lightly-loaded 1/2 wave rectifier will 
tend to charge all the way up to the peak voltage of the 
half-cycle... more like 1.4 * 120 = 160 volts.  Heavily loaded, it'll 
never get to that level, though.

> Am I doing something really stupid and missing something?

Probably not.  You certainly understand the circuit.  Note that your 
relay is a big current user:

I = 24v/280ohms = about 86ma. 

Mine can't be like that... 86ma X 3900 ohms would require 330 volts! 
I'll check my P.S. and report.

73,


George T. Daughters, K6GT

--
FAQ on WWW:               http://www.contesting.com/ampsfaq.html
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>