No, Rich, I'm not referring to the glitch resistor. I know that goes in series
with the plate supply. I am asking about the one that goes from the negative
power supply output to ground.
73,
Vic, K2VCO
Fresno CA
measures wrote:
>
> >
> >In the common circuit used for GG triode amplifiers that separates the B-
> >from
> >ground in order to allow for convenient plate and grid current metering,
> >there
> >is a 'safety resistor' from B- to ground.
> >
> >Most designs seem to use a value like 10 or 20 ohms. As G3sek
> ><http://www.ifwtech.demon.co.uk/g3sek/> points out, if you use the 'voltmeter
> >method' to measure grid current, the high value of the shunt resistor
> >requires a
> >higher value for the safety resistor (he suggests 1000 ohms) to keep the grid
> >metering accurate.
> >
> >My question is: What malfunction is this 'safety resistor' protecting us
> >against?
>
> ? Destructive surge current, provided that the resistor is installed
> where it belongs.
>
> >What could happen if it were omitted or opened in service?
> >
> ? This resistor belongs in the positive side of the hv supply, not the
> negative. When the glitch resistor is in negative circuitry, a positive
> to gnd arc elevates the cathode circuitry to many kilovolts. A glitch
> resistor needs to be stout enough to withstand repeated hv positive to
> gnd arcs.
>
> - Rich..., 805.386.3734, www.vcnet.com/measures.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|