>Have a SB200 linear and attemping to hook it up to a Kenwood TS940S.
>Kenwood (and the Manual) states that Pin 4 on the remote connector is
>Relay, Pin 2 is Ground, and Pin 6 is ALC. This is a 7 PIN DIN connector.
>I can not get closure of the relay between pins 4 and 2. Is there a
>special connector that I have to get from Kenwood? Is there some switch
>setting on the TS940 that activates the relay....
? As I recall, it's a white jumper wire.
- Rich..., 805.386.3734, www.vcnet.com/measures.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|