>
>When figuring the tank Z in an output pi network is it figued using the
>expected plate voltage under load or at idle? It makes quite a difference.
>
? u gotta look at the peak AC anode volts, loaded. For a triode, this
usually about 250v less than the supply. For a tetrode, this is pretty
close to the anode supply volts minus the screen supply volts.
- later, Lane
- Rich..., 805.386.3734, www.vcnet.com/measures.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|