>
>Have AL-80 (not A or B) with single 3-500Z. The manual indicates that it
>provides 0 - 30 negative volts for the transceiver input. The transceiver
>is an FT-757GX which manual indicates that the ALC input voltage range
>should be between 0 - 5 neg.
>
>My concern is that I might damage the transceiver in some way if in
>adjusting the ALC I allow in significantly more than 5 neg volts. How
>should I approach this?
>
Even if the V and polarity are compatable, the onset delay problem can
not be corrected until ALC is disconnected.
cheers, Luther
- Rich..., 805.386.3734, www.vcnet.com/measures.
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|