I checked my voltage at the outlet for my amp. and it measured 235
volts. This was measured with a B&K 20k ohm voltmeter. Factory setting
for the AL-1200 filament xfmr line voltage is setup for 245v. There are
taps for 232v and less, would it be advisable to switch my tap to the
232v setting??? Thanks de Phil W2GE
--
FAQ on WWW: http://www.contesting.com/ampsfaq.html
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|