Amps
[Top] [All Lists]

[AMPS] Blown TL922A... What to do?

To: <amps@contesting.com>
Subject: [AMPS] Blown TL922A... What to do?
From: 2@vc.net (measures)
Date: Tue, 5 Sep 2000 22:08:32 -0700
>
>> >The series resonance actually makes the input impedance of the 
>> >tank look like only a few ohms!
>> >
>> This is true only when the series resonance is not offset from the 
>> parasitic freq.  L-networks are never resonant.  When the resonance is
>> Near but not dead-on the parasitic freq., the L-network effect comes into
>> play and the potential is substantially increased.  
>
>You must be using a new definition of resonance. Can you tell me 
>what you mean?
>
zzzzz

>This is a series-resonance, not L-network, and it is shunting the 
>path the tube must drive on VHF.
>
L-networks transform Z.  They shunt not.  

>If the tank could freely pass harmonics, or step up the voltage at 
>VHF to high levels, the amplifier would be a TVI nightmare. 
> 
If the tank were a high-pass Pi, VHF parasitic oscillation would be 
unlikely.  

>> >It actually makes it impossible for the tube to drive significant 
>> >voltage at the tank at VHF! 
>> >
>> Ä  You seem to have missed the word "Near", Tom.  
>
>The impedance of the capacitor is highest at dc, and is reduced as 
>frequency is increased. That's why the tank is a low-pass network.
>
>If the parasitic is NEAR the fundamental frequency, or lower than 
>the fundamental frequency, it could indeed arc the tank 
>components over...maybe. 
>
At the HF/MF fundamental freq. there is not enough feedback C to sustain 
oscillation.  

>Most people know the tank is a poor pass system for VHF energy, 
>you might have a hard time confusing them. 
>
>> Ä  Which TV station is on 120MHz? 
>
>Nice try. Now we have single frequency parasitics exactly on 120 
>MHz, where the tuning capacitor has about ten ohms of reactance, 
>driving the tank capacitor with thousands of volts.
>
Mr. Rauch conveniently disappears the series-resonance in the Tune C to 
support his agenda.

>What happen to your claim about grid resonance at 80 MHz, did it 
>move in this application to fit your needs?

no.  The tubes can oscillate above grid resonance. 
>
>
later, Tom.  

-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>