Amps
[Top] [All Lists]

[AMPS] Blown TL922A... What to do?

To: <amps@contesting.com>
Subject: [AMPS] Blown TL922A... What to do?
From: 2@vc.net (measures)
Date: Fri, 8 Sep 2000 13:01:33 -0700
>
>    
>-----Original Message-----
>From: measures <2@vc.net>
>To: amps <amps@contesting.com>
To: <amps@contesting.com>
>Date: 08 September 2000 05:51
>Subject: Re: [AMPS] Blown TL922A... What to do?
>snip
>
>
>>>Has anyone been able to measure the frequency of oscillation in, for
>>>example, TL922? 
>>
>>The only case I have knowledge of involved loosely coupling a spectrum 
>>analyzer to the anodes of a seemingly stable* SB-220.  Whenever 
>>anode-current changed, damped wave ringing at c. 110MHz was observed.  
>>/*note: no bandswitch or Tune-C arcing took place during the test/
>>
>>>What dip frequencies are found with a GDO in a 922? 
>>
>>Measuring at the dc blocking C, typically c. 120MHz.  There is a slight 
>>variation depending on the setting of C-tune.  
>A few%, 10%, 25%?
>
As I recall, the variation was a few MHz.  
>
later, Steve

-  Rich..., 805.386.3734, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>