>
>On Sat, 04 Nov 2000 07:06:04 -0800, KB7WW Art Moe wrote:
>
>>One of the sockets is not making good contact with the filament,
>>both tubes will light in one socket but neither will light in the
>>other. I have measured the voltage at the connection of the choke
>>and the socket and have voltage there.
>>
>>Anyone have a cure for this???
>
>Unless you can replace the contact in the socket, I'd recommend a
>installing new socket.
>
Good advice. Do you have below the chassis cooling air direected at the
filament pins?
end
- Rich..., 805.386.3734, www.vcnet.com/measures.
end
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|