Amps
[Top] [All Lists]

[AMPS] Drive for 2x4-400A GG

To: <amps@contesting.com>
Subject: [AMPS] Drive for 2x4-400A GG
From: kg7da@foxinternet.net (kg7da)
Date: Thu, 16 Nov 2000 00:23:02 -0900
Hi Firson:

What is the plate voltage?
You will find that the 4-400 tubes require more plate voltage than the 3-500
or 3-400 for the same gain.

Marty
----- Original Message -----
From: Firson Maryutenli <firson@hotmail.com>
To: <amps@contesting.com>
Sent: Thursday, November 16, 2000 5:55 AM
Subject: [AMPS] Drive for 2x4-400A GG


>
> Hi All,
> Now I currently building Amplifier for SSB 80 meter band using two Eimac
> 4-400A tube in Grounded Grid Mode. I got problem from my tranceiver that
is
> not enough power for driving this amplifier until full output. With 100
watt
> drive only produce 600 watt output and plate current are quiet low only
> indicating betwen 300 to 400 ma. I have no maching input (tune input) and
> tranceiver output directly connected to filamen. How to design maching
input
> for this tube ? so I can drive this amplifier until full output for only
100
> watt drive.
>
> Thanks in advance
> Firson - YD1BIH
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> Share information about yourself, create your own public profile at
> http://profiles.msn.com.
>
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>