Amps
[Top] [All Lists]

[AMPS] AL-1500, AL-82, AL-1200, QRO???

To: <amps@contesting.com>
Subject: [AMPS] AL-1500, AL-82, AL-1200, QRO???
From: Michael Tope" <W4EF@dellroy.com (Michael Tope)
Date: Wed, 3 Jan 2001 03:59:43 -0800
Hi Chuck,

The club at my workplace recently picked-up an AL-82. So far it
seems like a very nice amplifier. It uses 2 x 3-500Z tubes which 
are considerably cheaper than the 3CX1200 and the 8877 tubes
used in the AL-1200 and AL-1500. The 3-500Z's are instant
on, so there is no waiting if you stumble across a pileup with
your amplifier off. Unlike many other 3-500Z amps, the AL-82
runs a fairly high plate voltage (3600VDC resting in the SSB 
position), so the amp is easily able to produce legal limit output 
with 100 watt rigs like the TS-850 we have at work.

I have also used the AL-1200, and the engineering model
of the AL-1500 (an old contesting buddy is a good friend of
W8JI). Both amps worked very well (the AL-1500 engineering
unit would run 2500 watts output key down, but I think it had 
a slightly larger than stock transformer in it). From my recollection,
the AL-1200 performed similarly to the AL-82 (its been over 10
years since I have used the AL-1200). The only caveats I can 
think of for the AL-1500 are the higher tube cost, sensitivity to
excessive grid current (characteristic of the 8877 tube), and 
warm up time of the indirectly heated cathode. The AL-1200 
doesn't have the problem of grid current sensitivity, but it
does use a pretty expensive tube. I don't recall if the 3CX1200
tube used in this amp is instant on or not. I should also mention
that the AL-1500 will require less drive power to reach legal
limit (~65 watts versus ~100 watts) than the AL-1200 or AL-82. 

The other technophiles on the reflector may be able to fill you 
in on some of the finer points of these fine amps. 

73 de Mike, W4EF..................................................






----- Original Message ----- 
From: "Chuck Adkins - K8CPA" <k8cpa@arrl.net>
To: <amps@contesting.com>
Sent: Monday, January 01, 2001 6:41 AM
Subject: [AMPS] AL-1500, AL-82, AL-1200, QRO???


> 
> Which ones are better???
> 
> 
> -Chuck K8CPA
> http://www.qsl.net/k8cpa -- My WebPage
> http://multi.mode.listbot.com -- Digital Amateur Comm.. Mailing list
> 
> 
> 
> 
> 
> 
> 
> 
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/amps
> Submissions:              amps@contesting.com
> Administrative requests:  amps-REQUEST@contesting.com
> Problems:                 owner-amps@contesting.com
> 
> 



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>