Amps
[Top] [All Lists]

[AMPS] receivers

To: <amps@contesting.com>
Subject: [AMPS] receivers
From: W8JI@contesting.com (Tom Rauch)
Date: Mon, 15 Jan 2001 17:44:28 -0500
Here are some specs:


But back to Tom's point.  I went through a 
number of swept test data and
was
surprised to find that my generalization was not 
true in all cases.  Here
is
the 5-kHz data for the rigs I checked:

(In alphabetical order...)

Rig                     BDR          IMD DR
Elecraft K2             126          88
ICOM IC-706 MkII G      86           74
ICOM IC-756             98           67
ICOM IC-756 Pro         104          80
ICOM IC-775DSP          104          77
Kenwood TS-570D         87           72
Ten-Tec Omni 6+         119          86
Yaesu FT-1000MP         111          83
Yaesu FT-1000MP Mark V  106          78
In the vast majority of cases, the numbers are 
less than at the 20 kHz
spacing, but the amount of variation between 
similarly priced radios was
unexpected.

Note that some of the above rigs would 
experience a _blocking_ response
from
an S9+30 signal that was more than 5 kHz away.

end of repost......


OK, if you look at the above, you will see most 
rigs aren't so good at close spacing. THe 
Kenwood 570 blocks about the same as a IC-706.

My modified Drake R4C's block at anywhere from 
zero to plus ten dBm at 1 kHZ spacing!



  





73, Tom W8JI
w8ji@contesting.com

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>