Amps
[Top] [All Lists]

[AMPS] TS-2000

To: <amps@contesting.com>
Subject: [AMPS] TS-2000
From: Ian White, G3SEK" <g3sek@ifwtech.com (Ian White, G3SEK)
Date: Fri, 3 Aug 2001 20:35:51 +0100
Tom Rauch wrote:
>
>There is also a second problem that is almost always overlooked. Some 
>rigs switch into transmit while the synthesizer is still moving to a new 
>frequency, while others switch before the thing even moves! One popular 
>high-end DSP rig does that, you can tell them in pile ups because they 
>are the rigs that thump on top of the DX station when they are working 
>split frequency.
>
Model numbers?

A similar problem used to happen with the old Yaesu FT-221. This was
notorious for key-clicks, yet it showed a very reasonable keying
waveform on a scope. It turned out to be the keyed IF stage, which burst
into oscillation each time the operating point was changing between on
and off.

The diagnostic was to connect a 10-50K pot across the key jack, and tune
around the signal at various settings of the pot, down to zero ohms. At
a few hundred ohms, it showed a burbling FMy signal which swept over
10kHz or more.

The point was, the scope showed nothing because the problem wasn't in
the time domain; but a second RX (or spectrum analyser) wouldn't show
the spurious either, until the problem was held in a steady state.

73 from Ian G3SEK          Editor, 'The VHF/UHF DX Book'
                          'In Practice' columnist for RadCom (RSGB)
                           http://www.ifwtech.com/g3sek

--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>