Amps
[Top] [All Lists]

[AMPS] Finding the Q of a Coil

To: <amps@contesting.com>
Subject: [AMPS] Finding the Q of a Coil
From: 2@vc.net (2)
Date: Sun, 7 Oct 2001 11:22:31 -0700
>
>You are nearly right, Q is  the reactance divided by the equivalent
>resistance, that's the sum of ohmic losses plus the RF losses.
>Generally speaking anyway, what counts is often the circuit Q rather than
>the single component Q.
>For example, after all this is the AMP reflector, one can build a coil with
>Q=300 but the PI network where that coil will work could have been designed
>for a loaded value Q=10 (or even 2) , thus accepting lower quality inductors
>without any practical problem.
>Incidentally, sometimes the current and dissipation capabilities, rather
>than the Q, are much stringent parameters with inductors.
>
//   Good points, Mauri.  
>


-  R. L. Measures, 805.386.3734, AG6K, www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>