We can buy the Samuel Adams in Sweden, I buy it now and then,
it´s ok but I rather get the stuff from G, DL and OK land where
they
also make some excelent beer.
Talking about Samuel, if you want to get good beer get the Samuel
Smith from England.
73, Jim SM2EKM
PS: Molson I can drink but the rest of the North American chemical
piss water I can do without, I used to dring Coors back in the
seventies
but I think I can do without it these days.
73, Jim SM2EKM
PS again: Beats me what this had to do with tuned input!!, Now if
I only
could get a new bandswitch waffer for my old SB-220 I sure would be
in business again.
------------------------------------------------------------------------
---------------------
-----Ursprungligt meddelande-----
Från: stevek@jmr.com [SMTP:stevek@jmr.com]
Skickat: den 9 oktober 2001 01:07
Till: bjk@ihug.co.nz
Kopia: amps@contesting.com
Ämne: RE: [AMPS] Tuned Input, what me worry
The best U.S. beers come from microbreweries who don't add any chems,
but
they don't export and the beer "expires" pretty quickly. It's best to
grab
it out of the fermentation tank and tap right into that, preferably by
installing one's mouth directly beneath the spigot.
The only "real American beer" that is produced in volume, in my
opinion, is
made by Samuel Adams (Boston Brewing) and I don't think they export
that,
either. In fact, many of the Samuel Adams brews are not sold at all in
several States, you have to be close to one of the refineries. Lucky
for
me, I am.
Pass me another brew, will ya, mate?
> PS I have enjoyed Anchor Steam etc in the USA , but was depressed how
hard
> it was to get good US beer in most outlets.
> 73
> end
> Barry Kirkwood PhD ZL1DD
> Signal Hill Homestay
> 66 Cory Road
> Palm Beach
> Waiheke Island 1240
> NEW ZEALAND
> www.waiheke.co.nz/signal.htm
> ----- Original Message -----
> From: Steve Katz <stevek@jmr.com>
> To: <KG6DV@cs.com>; <amps@contesting.com>
> Sent: Tuesday, 09 October, 2001 11:52 AM
> Subject: RE: [AMPS] Tuned Input, what me worry
>
>
> >
> > Ron, doesn't a 1dB pad only provide 1dB of impedance stabilization?
> >
> > Think about it, and then have a beer. I'll have one, too!
> >
> > "Hang loose," as they say there...
> >
> > WB2WIK/6
> >
> > "Each success only buys an admission ticket to a more difficult
> problem." --
> > Henry Kissinger
> >
> > > -----Original Message-----
> > > From: KG6DV@cs.com [SMTP:KG6DV@cs.com]
> > > Sent: Monday, October 08, 2001 3:50 PM
> > > To: amps@contesting.com
> > > Subject: [AMPS] Tuned Input, what me worry
> > >
> > > There is a lot of discussion lately on how to design a proper
tuned
> input
> > > .... that topic and beer have dominated lately. 16 ways to
figure the
> Q
> > > of the input circuit, 17 ways to tell a really fine beer. I can
> > > understand the value of passing on your knowledge of how to judge
a
> really
> > > good beer, but a tuned input ....why bother.
> > >
> > > I built way too many tuned input circuits till I gave it up ...
too
> much
> > > work. I ended up borrowing an approach from the old timers (you
here
> know
> > > who you are) remember swamping. A variation on the old method
works
> for
> > > me. I use a T-PAD attenuator.
> > > The great thing about a T-PAD attenuator is the fact that the
load on
> the
> > > output side can swing a great deal while the input will stay put
> > > wonderfully. Does this sound like whats needed for an input
circuit,
> it
> > > does to me. These transmitting tubes display a fairly large
swing in
> load
> > > at different drive levels, not what your exciter needs to see.
> > > I design the T-PAD for 1db attenuation, nobody needs to loose a
lot of
> > > drive power.
> > > I size the resistors (non inductive of course) in each of the
three
> legs
> > > to handle the dissipation and ..... wallah, you have an input
circuit
> that
> > > will show your exciter a nice consistent 50 ohm load. What could
be
> > > simpler. Its worked for me for years.
> > >
> > > Now we will all hear whats wrong with this approach .... or maybe
just
> > > some more great beer theory.
> > >
> > > Ron KH6DV
> > > Kaneohe Hawaii
> > >
> >
> > --
> > FAQ on WWW: http://www.contesting.com/FAQ/amps
> > Submissions: amps@contesting.com
> > Administrative requests: amps-REQUEST@contesting.com
> > Problems: owner-amps@contesting.com
> >
> >
>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
<<Fil: RE_ [AMPS] Tuned Input, what me worry.TXT>>
--
FAQ on WWW: http://www.contesting.com/FAQ/amps
Submissions: amps@contesting.com
Administrative requests: amps-REQUEST@contesting.com
Problems: owner-amps@contesting.com
|