Amps
[Top] [All Lists]

[AMPS] Iron regulated screen supply?

To: <amps@contesting.com>
Subject: [AMPS] Iron regulated screen supply?
From: 2@mail.vcnet.com (rich)
Date: Wed, 30 Jan 2002 11:17:06 -0800


>
>Contemplating building a tetrode linear from the accumulated treasures of
>years.
>Thinking back on the 30S-1 approach, and amateur as opposed to production
>budgeting.
>Thoughts:
>If one is starting from scratch with things accumulated from junk sales
>(with an aging ham population used equipment seems to be a buyer's market!)
>then a power supply made by stacking a frinstance 400V @ 1A peak with say
>3kV@ 1A  peak is not such a bad concept : 

//  An anode PS sourced shunt 400v screen regulator is cheaper, less 
complex, more RF immune, and more accident resistant than a 1A screen 
supply.  

>the screen load is trivial, one is
>basically making a slightly unorthodox anode supply.

Screen dissipation is not trivial.

>Again, tuned chokes are not such a big deal, and maybe plain choke input
>with a generous reservoir capacity and generous bleed current might show
>almost as good dynamic regulation. 

When an old timer [W6SDM] recommended againt such because of a transient 
regulation problem, I went home, fired up my DC oscilloscope and saw for 
myself.  When the load current decreased, there was a substantial 
V-spike.  When the load current increased, there was a substantial V dip. 
 On a meter, I could not see the problem.  

>After all tetrode high fi audio amps run
>low distortion (albeit with negative feedback) ...

//  Bingo

good luck, Barry

-  R. L. Measures, a.k.a. Rich..., 805.386.3734,AG6K, 
www.vcnet.com/measures.  
end


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>