[AMPS] Filamant CT

[w3nr@vol.com (Ed W3NR)]

        The filament transformer I am using with an 811A amp 
has no CT for the B- return, so I just tapped one side of the 
filament. Is this a good idea or am I asking for a hum problem 
here. If I make a CT can I use a couple of 2 to 5 watt 20-200 ohm 
resistors ?? Thanks

Ed W3NR



--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com