Amps
[Top] [All Lists]

[Amps] GS-35B Amp, PA3CSG design

To: <amps@contesting.com>
Subject: [Amps] GS-35B Amp, PA3CSG design
From: kayser@sympatico.ca (Larry Kayser)
Date: Sat, 29 Jun 2002 22:02:05 -0400
Greetings:

I am considering building this amplifier for a project here.  The available 
information is a little light on the design of the mounting ring assembly 
for the Grid.  I would like to get in touch with someone who has built one 
of the PA3CSG design and has direct knowledge of a working design for the 
grid mounting assembly.  The assembly looks like two plates with four 
aluminum standoffs providing about 1 cm or  3/8 of an inch for the air 
flow.  The PA3CSG documentation is not clear (to me in any case) on the 
exact design to use for the grid mount.

If anyone has additional information on this subject please get in touch 
via direct email.

If there is a better forum for this inquiry I would also appreciate that 
information as well.

Larry
VA3LK


<Prev in Thread] Current Thread [Next in Thread>