John, the solution is obviously to just keep talking (transmitting), since
the problem only occurs when receiving!
Does sound like a transformer to case internal short...
-WB2WIK/6
"If everything seems under control, you're just not going fast enough." -
Mario Andretti
> -----Original Message-----
> From: John [SMTP:hydro@naturecoast.net]
> Sent: Wednesday, October 02, 2002 11:18 AM
> To: amps@contesting.com
> Subject: [Amps] Problem with SB-1000 Power Supply
>
> Hi all
> I have a very interesting problem with my SB-1000 Heathkit .....This is
> the
> same amp as the ameritron AL80a with a single 3-500z
>
> Hears what happen.... I turn the amp on to use it, Talk on it for a few
> minutes, The amp blows the fuse for no reason while in receive... no pops,
> cracks, nothing ...just went dead while in standby
>
> I pull the tube test ....still blows fuse.... Test diodes...Check out OK,
> but replace them anyway..Still blows fuse...Check caps .....Seem ok...
> just
> for test I leave them out .Still blows fuse with NO caps in amp.... Put it
> all back together, disconnect the B+ ....No dice
>
> So I am just about stumped.... I disconnect the HV negative from chassis
> ....Power it up
> It comes on .... Now the power supply is totally isolated from the amp....
> As soon as I connected the negative HV from the power supply to chassis
> ground it blows the fuse.....
>
> So the only thing I can come up with is the transformer must have some
> kind
> of internal short, Because there is no problem in the diode board or caps
> &
> the power supply will work as long as you do not connect the HV negative
> to
> the chassis
>
> Any ideas .....Richard or Tom ???
>
> thanks john
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
|