> >2 wrote:
> >>
> >> >When adjusting the bias for a 2sc2879 amp operating at 15v, what
should the
> >> >resting collector current be for reasonably linear operation? I've
seen
> >> >values
> >> >suggested that range from 100 to 200 ma per transistor.
> >> >
> >> I use 200 per.
> >
> >Hi Rich,
> >
> >Just to be 100% sure -- since most of these amps have boards with a pair
of
> >transistors -- do you mean 200 per TRANSISTOR or 200 per BOARD?
> >
> The mfg of the radio said 200 for a pair. That was not clean enough, so
> I went with 200mA ea.
> cheers, Vic
What was the flange temperature?
Remember that unless you're using a temperature
compensating bias circuit the resting collector current
will rise as the heatsink, flange, and B-E junction(s)
increase in temperature. In a nutshell, what is Class B
and a little dirty at room temperature can quickly become
Class AB and clean after the first QSO--especially with
15 volts on the collector(s).
--
-------------------------------------------------------------------
-=[Bill Eitner]=-
Link to A.M. Tutorial and rec.radio.cb FAQ:
http://www.bigradios.com/kd6tas
-------------------------------------------------------------------
|