Hi Osten,
on the schematic of FL-2100Z there are two wafers in PA. One is S7-a which
adds necessary capacitance for circuit to resonate on
160 and 80 meters. Plate capacitors tied to wafer S7-a are: C35 250pf/3KV
and C36 100pf/3KV. ( Look around the pa compartment for those capacitors).
They would help you to find wafer S7-a. On wafer S7B, the lowest contact
CCW is for 160 m .That contact has also tied following Antenna additional
capacitors C31, C32,C33, C34 and all three sections of VC2, which is 3 x 500
pf antenna loading variable capacitor. The missing link is the wire which
connects above mentioned contact for 160 to the end of large coil, ( the end
with closely wound wire). To the point as mentioned are also connected two
sections of VC2. That is closesest as I have tried to describe.IF you see
the third wafer, then it could be only, that the 160 and 80 meters are tied
to that wafer ( missing one?? it is not marked separately!!). In any case,
follow the values of above mentioned capacitors, that would lead to
conclusion what is what?
Hope that helps
Best regards and keep one hand in the back pocket,
Nermin S58DX
|