| To: | <amps@contesting.com> |
|---|---|
| Subject: | [Amps] 4-1000A Operating position |
| From: | millenniumfalcon at cableone.net (Jim Isbell) |
| Date: | Wed May 28 09:31:04 2003 |
Can a 4-1000A be operated on its side? With air flow of course. I have the full socket and chimney set up but my chassis is only 6.5 Inches high so the chimney would just fit if the tube could operate on its side. But looking at the plate construction with no lower support, I dont think this will work. |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Amps] Resonance in PiNetworks, 2 |
|---|---|
| Next by Date: | [Amps] Power Transformer, Jim Isbell |
| Previous by Thread: | [Amps] 2:1 Transformer, 2 |
| Next by Thread: | [Amps] 4-1000A Operating position, Phil Clements |
| Indexes: | [Date] [Thread] [Top] [All Lists] |