Re: [Amps] warm up times of tubes?

[Norman Hockler <norsan@bright.net>]

The Eimac spec says 8 min BEFORE applying HV or drive.

Therefore thae answer on the YC-156 is NO.

Norm  N8NH


At 10:05 AM 11/23/03 +0000, you wrote:

> Are warm up times of various tubes set in anyway with regards to what your
> going to "hit" them with after X minutes? Or is it not related.
>
> For example if a tube quotes 6 minutes to warm up (YC156) is there any way
> one can reduce this  if you "promise the tube" its wont be working too hard
> for the next 2-3 minutes? ..or in general operation.
>
> Your advice please...
>
> Neil G0JHC
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps